Accelerator; Handlebar; Adjusting Fork; Adjusting The Idle Speed - Beta EVO 4T Owner's Manual

3

ACCELERATOR

ADJUSTING THE IDLE SPEED

A
In order to perform this operation correctly,
we advise you to do it when the engine
is hot, connecting an electric revolution
counter to the spark plug wire. Then use
a screwdriver on register screw A to
calibrate the minimum with 1.100÷1.200
rpm.

HANDLEBAR

The handlebar can be adjusted by rotating
it back and forth.
- To adjust the handlebar loosen screws 1.
- Position the handlebar according to
requirements.
- Tighten to the torque indicated.
1
20Nm

ADJUSTING FORK

ADJUSTING THE REBOUND
DAMPER
The hydraulic brake unit in extension
determines the behaviour in the extension
phase of the fork and can be adjusted us-
1
ing screw 1. Turning clockwise increases
the action of the brake in extension, while
rotating counter-clockwise decreases the
action of the brake in extension.
For standard calibration, refer to page
.
11
GB
30