Honeywell Dolphin 9900 User Manual page 85

Comm Section
The serial port settings in the Comm section determine the interaction between ScanWedge and the serial
port.
Comm Section Description
Key
Powerout Enables and disables power out of the
serial port for ScanWedge specifically.
General power out settings are
established in the registry.
The serial port powers out 5V at
500mA.
EnablePrefixData Enables or disables all prefix data
received via COM port after a
successful scan.
All prefix data is defined in the
Section
EnableSuffixData Enables or disables all suffix data
received via COM port after a
successful scan.
All suffix data is defined in the
Section
Dolphin® Power Tools User's Guide
Settings
(see page 5-3).
Settings
(see page 5-3).
Rev A
8/6/08
Default Available Values
Value
0 0=Disabled; do not power out when
scanning with ScanWedge
1=Enabled; power out when
scanning with ScanWedge.
2=No change for ScanWedge. This
means that ScanWedge is not
altering the default power out
setting in the registry. The
terminal defaults to the power-out
setting in the registry.
0 0=Disabled
1=Enabled
0 0=Disabled
1=Enabled
5 - 7