Decode Section - Honeywell Dolphin 9900 User Manual

Decode Section

The Decode section specifies decoder settings when using the decoder with ScanWedge.
ScanWedge Entry
Enable
Trigger
ContScan
PowerSave
ScanTimeout
ScanMode
LinearRange
5 - 8
Description
Enables and disables the decoder for
ScanWedge.
Sets the key used by ScanWedge to
initiate a scan/decode. The key is
registered as a system hotkey and
cannot be registered as a hot key by
any other applications.
Enables and disables continuous
scan.
Enables and disables power saving
mode.
Specifies the decode time out in 1/
1000th seconds. If a barcode is not
decoded within the specified timeout
an audio and visual notification
indicates that an error occurred.
Specifies the decode mode.
Specifies the linear search range to
be used while in ALD mode.
Rev A
8/6/08
Default Available Values
Value
1 0=Disabled; decoder is not
used.
1=Enabled; decoder sends bar
code data as keystrokes to
the active window.
42 42=OnScan or Scan key
0 0=Disabled; trigger key must be
released between scans.
1=Enabled; data is
continuously decoded and
sent to the application while
the trigger key is depressed.
1 1=Enabled; the decoder
automatically initializes and
un-initializes as needed. A
slight delay occurs when the
trigger is activated.
0=Disabled; the decoder
initializes when the utility
starts and un-initializes
when the utility terminates.
5000 X=Time in 1/1000th of a
second.
1 1=Full Omni/Normal
2=ALD (Aggressive Linear
Decode) mode
4=Quick Omni
3 X=Range from 1 to 6.
1 indicates a tight vertical
range near the aimer.
6 indicates a vertical range
of the entire height of the
imager.
Dolphin® Power Tools User's Guide