Honeywell Dolphin 9900 User Manual page 60

Profile Subsections
Each Profile subsection contains the keys that configure the radio connection from the terminal to the
network.
Key Description
Private Key Private keys are used with certain types of
EAP authentication.
Priv Key Private keys can be locked by passwords.
Password
WEP Key Mode being used by the WEP keys (in Key1–
Key4 keys).
Mode
Key validation occurs when DeviceConfig is
loaded on the terminal (often during
AutoInstall), not when you save the
DeviceConfig.exm file.
WEP Key1– In fields Key 1—Key 4, enter the specific key.
The format of each key must match the key
Key4
length type selected in the WEP Key Mode
key.
To use dynamic keys in your configuration,
leave all the key fields blank.
Active Key Enter the number of the key that you want to
be active in this configuration.
3 - 6
Default
Value
N/A
N/A
N/A
N/A
N/A
Rev A
8/6/08
Available Values
Enter the address on the
Dolphin terminal of the private
key.
The private key must be
located on the Dolphin
terminal!
Enter the password that
unlocks the private key.
ASCII uses all alpha numeric
characters.
HEX uses only numerics and
A-F.
Valid lengths are as follows:
• 64-bit ASCII=5
• 128-bit ASCII=13
• 64-bit HEX=10
• 128-bit HEX=26
User-defined
1, 2, 3, or 4
Dolphin® Power Tools User's Guide