Comm Section - Honeywell Dolphin 9900 User Manual

Comm Section

The serial port settings in the Comm section determine the interaction between ScanWedge and the serial
port.
Comm Section Description
Key
Enable Enables (or disables) ScanWedge to
receive and interpret data from the
serial port.
AutoConnect Enables or disables the auto-
connection between ScanWedge
and the serial port.
Port Specifies the serial port to use to
connect to ScanWedge.
Note: This setting is ignored for Port 4.
FlowControl Specifies the flow control method to
use–software only, hardware only, or
software and hardware.
Note: This setting is ignored for Port 4.
BaudRate Specifies the baud rate for the serial
port.
Note: This setting is ignored for Port 4.
Parity Specified the parity for the connection.
Note: This setting is ignored for Port 4.
DataBits Specifies the number of bits per byte to
use.
Note: This setting is ignored for Port 4.
StopBits Specified the number of stop bits to
use.
Note: This setting is ignored for Port 4.
5 - 6
Default
Value
0
0
4
38400
0
8
0
Rev A
8/6/08
Available Values
0=Disabled; no data is received
1=Enabled; ScanWedge receives
data from the serial port
(specified in the Port key) as
keystrokes to the foreground
application.
0=Disabled; ScanWedge opens the
serial port immediately at startup
and doesn't close until
ScanWedge is closed. This is the
recommended setting when the
serial port is port 2 or 3.
1=Enabled; ScanWedge connects to
the serial port when a power
source is detected and
disconnects when the power
source is removed/not detected.
The use of port 4/6 is not
encouraged.
1=Software (Xon-Xoff)
2=Hardware
3=Hardware and software
4=No flow control
X=The appropriate baud rate.
0=No parity
1=Odd parity
2=Even parity
3=Mark parity
4=Space parity
X=Number of bits per byte
0=1 stop bit
1=1.5 stop bits
2=2 stop bits
Dolphin® Power Tools User's Guide