BattMon
BattMon programs the terminal's LEDs to monitor the charge status of the battery.The LEDs are located
on the top, front panel of Dolphin terminals.
To Enable BattMon
1. Tap Start > Power Tools. The
2. Tap the BattMon icon once
When the battery is at 100%, the green LED lights solid green.
When the battery is charging the green LED flashes.
Note: To start BattMon automatically after each hard reset, enable the BattMon Program section of the
File
(see page 4-1).
To Disable BattMon
Navigate to the
Power Tools Main Window
OR
Select Exit on the
Command Bar Menu
Command Bar Menu
When BattMon is enabled, a smaller BattMon icon appears in the Command bar at the bottom of the
Today screen.
Tap this icon to open the Command bar menu:
Menu Item
This item ...
Status
Displays the battery charge status in percentage.
Enable
Enables and disables BattMon without exiting BattMon.
About
Provides version and copyright information for BattMon.
Exit
Closes BattMon. The icon no longer appears in the Command bar.
6 - 2
Power Tools Main Window
. After activation, BattMon monitors the battery's charge status.
(see page 1-2) and tap the BattMon icon again.
(page 6-2).
Rev A
8/6/08
(see page 1-2) appears.
.
Dolphin® Power Tools User's Guide
Autorun.exm