Configuring GVRP
Configuring GVRP
This section describes how to configure GVRP using Alcatel-Lucent's Command Line Interface (CLI)
commands.
Enabling GVRP
GVRP is used primarily to prune unnecessary broadcast and unknown unicast traffic, and dynamically
create and manage VLANs. GVRP has to be globally enabled on a switch before it can start forwarding
GVRP frames.
To enable GVRP globally on the switch, enter the
-> gvrp
To disable GVRP globally on the switch, use the no form of the gvrp command as shown:
-> no gvrp
Note. Disabling GVRP globally will lead to the deletion of all learned VLANs.
GVRP can be enabled on ports regardless of whether it is globally enabled or
become an active participant, you should enable GVRP globally on the switch. By default, GVRP is
disabled on the ports. To enable GVRP on a specified port, use the
For example, to enable GVRP on port 2 of slot 1, enter:
-> gvrp port 1/2
Similarly, to enable GVRP on aggregate group 2, enter:
-> gvrp linkagg 2
To disable GVRP on a specific port, use the no form of the command as shown:
-> no gvrp port 1/2
Note. GVRP can be configured only on fixed, 802.1 Q and aggregate ports. It cannot be configured on
mirror, aggregable, mobile, and MSTI Trunking ports.
OmniSwitch 6800/6850/9000 Network Configuration Guide
gvrp
command at the CLI prompt as shown:
gvrp port
March 2008
Configuring GVRP
not.
However, for the port to
command.
page 5-7