Interface Configuration Mode Commands - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Using ACL Manager
Command
ip access-list resequence access-list-name
starting-sequence-number increment
time-range time-range-name
no time-range time-range-name

Interface Configuration Mode Commands

The interface command (Global Configuration Mode) invokes the Interface Configuration Mode, which
is used to associate ACLs with switch interfaces. The following commands are available in this mode:
Command
ip access-group {number | name} {in | out}
no ip access-group {number | name} {in | out}
end
exit
OmniSwitch 6800/6850/9000 Network Configuration Guide
Description
Renumbers the permit and deny statements in the
named ACL using the specified starting sequence num-
ber and increment value.
By default the number 10 is used for the first statement
of an ACL and the increment value is set to 10.
Examples:
ip access-list resequence TestACL1 10 10
ip access-list resequence TestACL2 1 4
ip access-list resequence 102 20 10
Creates a time range with the specified name and
invokes the Time Range Configuration Mode.
Examples:
time-range range1
no time-range range1
Description
Associates the specified ACL number or name as an
incoming or outgoing filter. The ACL is applied to the
slot/port that was specified with the interface command.
Use the no form of this command to remove the associa-
tion with specified ACL number or name.
Note: It is possible to associate both an incoming and
outgoing ACL with the same interface.
Examples:
ip access-group 10 in
ip access-group acl_out_1 out
no ip access-group 10 in
Exits the Interface Configuration Mode and returns to
the Privileged Exec Mode.
Exits the Interface Configuration Mode and returns to
the Global Configuration Mode.
March 2008
ACLMAN Modes and Commands
page 28-11