Configuring Autonegotiation And Crossover Settings; Enabling And Disabling Autonegotiation - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual
Hide thumbs
Also See for OmniSwitch 6800 Series:
- Management manual (292 pages) ,
- Hardware user's manual (134 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
Setting Ethernet Parameters for Non-Combo Ports
To configure the inter-frame gap on an entire slot, enter interfaces, followed by the slot number, ifg, and
the desired inter-frame gap value. For example, to set the inter-frame gap value on slot 2 to 10 bytes, enter:
-> interfaces 2 ifg 10
To configure the inter-frame gap on a single port, enter interfaces, followed by the slot number, a slash (/
), the port number, ifg, and the desired inter-frame gap value. For example, to set the inter-frame gap value
on port 20 on slot 2 to 10 bytes, enter:
-> interfaces 2/20 ifg 10
To configure the inter-frame gap on a range of ports, enter interfaces, followed by the slot number, a slash
(/), the first port number, a hyphen (-), the last port number, ifg, and the desired inter-frame gap value. For
example, to set the inter-frame gap value on ports 20 through 22 on slot 2 to 10 bytes, enter:
-> interfaces 2/20-22 ifg 10
As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet
before the slot number. For example, to set the inter-frame gap value on port 20 on slot 2 to 10 bytes and
document the port as Gigabit Ethernet, enter:
-> interfaces gigaethernet 2/20 ifg 10
Note. Since the interfaces ifg command is only supported on Gigabit interfaces, only the gigaethernet
keyword should be used.
Configuring Autonegotiation and Crossover Settings
The following subsections describe how to enable and disable autonegotiation (see
Disabling Autonegotiation" on page
Settings" on page
37-17).
Enabling and Disabling Autonegotiation
By default, autonegotiation is enabled. To enable or disable autonegotiation on a single port, a range of
ports, or an entire slot, use the
page 37-17
and
"Setting Combo Ethernet Port Parameters on OmniSwitch 6800 and 6850 Switches" on
page 37-18
for more information).
To enable or disable autonegotiation on an entire switch, enter interfaces, followed by the slot number,
autoneg, and either enable or disable. For example, to enable autonegotiation on slot 2, enter:
-> interfaces 2 autoneg enable
To enable or disable autonegotiation on a single port, enter interfaces, followed by the slot number, a
slash (/), the port number, autoneg, and either enable or disable. For example, to enable autonegotiation
on port 3 on slot 2, enter:
-> interfaces 2/3 autoneg enable
To enable or disable autonegotiation on a range of ports, enter interfaces, followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, autoneg, and either enable or disable.
For example, to enable autonegotiation on ports 1 through 3 on slot 2, enter:
-> interfaces 2/1-3 autoneg enable
page 37-16
37-16) and configure crossover settings (see
interfaces autoneg
command. (See
OmniSwitch 6800/6850/9000 Network Configuration Guide
Configuring Ethernet Ports
"Enabling and
"Configuring Crossover
"Configuring Crossover Settings" on
March 2008
Advertisement
Table of Contents
