Ricoh K-C3 Service Manual page 169

B245/B276/B277/B268/B269 Service Manual
ADF Adjustment (
6006*
NOTE: Available menus depend on the machine model and its configuration.
ADF Adjustment (StoS/Front Regist) [–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
6006 1 Adjusts the side-to-side registration for the front side of the original, for ADF
mode. Use the
ADF Adjustment (Leading Regist)
6006 2 Adjusts the leading edge registration for ADF mode. Use the
"+" or "–" before entering the value.
ADF Adjustment (Trailing Erase)
6006 3 Adjusts the trailing edge erase margin for ADF mode. Use the
"+" or "–" before entering the value.
ADF Adjustment (StoS/Rear Regist) [–5.0 ~ +5.0 / 0.0 / 0.5 mm/step]
6006 4 Adjusts the side-to-side registration for the rear side of duplex originals, for ADF
mode. Use the
ADF Adjustment (Sub-scan Magnif) [–0.9 ~ +0.9 / 0.0 / 0.1 %/step]
6006 5
Adjust the sub-scan magnification for the ADF.
ADF Adjustment (Original Curl Adj) [0 = No / 1 = Yes]
Enables or disables the skew adjustment for the reverse sides of originals.
6006 6
When you enable SP6-006-6, adjust the distance of the skew adjustment (SP
6006 7).
ADF Adjustment (Skew Correction) [–20 ~ +20 / 0 / 1 mm/step]
6006 7 Specifies the distance of the skew adjustment. SP 6006 7 is effective when you
enable SP 6006 6 (ADF Adjustment [Original Curl Adj]).
ADF Free Run
6009
6009 1 Performs an ADF free run. Press "ON" to start; press "OFF" to stop.
Stamp Position Adjustment
6010
6010 1 Adjusts the stamp position in the sub-scan direction. for the fax mode.
Display ADF/APS
6901
6901 1 Displays the status of the ADF original size sensors (
ADF Shading Time
6910*
p.114
key to select "+" or "–" before entering the value
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
[–3.0 ~ +3.0 / –1.0 / 0.1 mm/step]
key to select "+" or "–" before entering the value.
[0 ~ 60 / 10 / 1 s/step]
[–10 ~ +10 / 0 / 1 mm/step]
p.191).
18-Jan-06
key to select
key to select
160