Ricoh K-C3 Service Manual page 166

B245/B276/B277/B268/B269 Service Manual
counter will both increment by two for each A3/11" x 17" sheet.
Optional Counter Type
5113*
5113 1 Selects the corresponding key for installed devices such as coin lock.
Clr-OP Count Remv
5120*
Determines under which conditions the copy job settings are reset when the key
counter is removed. With 0, the settings are cleared if the counter is removed at
the end of a job or midway through a job. With 1, they are only cleared if the
5120 1
counter is removed at the end of a job. With 2, they are not cleared at all, under
either condition. With duplex copies, the job settings are always preserved,
regardless of the setting of this SP mode.
Count Up Timing
5121*
Selects whether the key counter increments at time of paper feed-in or at time of
5121 1
paper exit.
APS Mode
5127*
5127 1 Enables or disables the APS mode..
PM Alarm Interval (Printout) [0 ~ 9999 / 0 / 0K copies/step]
5501*
5501 1 Specifies when the PM alarm occurs.
Memory Clear
5801
5801 2 Engine (
Machine Free Run
5802
Starts a free run of both the scanner and the printer. Press "ON" to start; press
5802 1
"OFF" to stop.
Input Check
5803
( p.176)
0: None
11: MF key card (Increment)
12: MF key card (Decrement)
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
[0 = Enabled / 1 = Disabled]
p.174)
18-Jan-06
157