Table of Contents
Advertisement
Monitor connector board
Description
Monitor connector board (includes cable)
Before removing the monitor connector board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service door (see
b.
Display assembly (see
c.
Bottom cover (see
Remove the monitor connector board:
1.
Disconnect the monitor connector board cable (1) from the system board.
2.
Remove the Phillips PM2.0×2.25 broad head screw (2) that secures the monitor connector
board to the top cover.
3.
Remove the monitor connector board (3) and cable.
Reverse this procedure to install the monitor connector board.
62
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
33), and then remove the following components:
Service door on page
34)
Display assembly on page
Bottom cover on page
46)
54)
Spare part number
730901-001
Advertisement
Table of Contents
