Table of Contents
Advertisement
4.
Remove the hard drive.
5.
If it is necessary to disassemble the hard drive, perform the following steps:
a.
Position the hard drive with the connector toward you.
b.
Disconnect the hard drive connector cable (1) from the hard drive.
c.
Remove the four Phillips PM3.0×3.25 screws (2) that secure the hard drive bracket to the
hard drive.
d.
Remove the hard drive bracket (3) from the hard drive.
The hard drive bracket, hard drive connector cable, and screws are available in the Hard
Drive Hardware Kit, spare part number 731424-001.
Reverse this procedure to install the hard drive.
36
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Advertisement
Table of Contents
