HP 11 Instructions

Enabling battery safety mode, disabling battery safety mode

Hide thumbs Also See for 11:

The following instructions apply solely to the HP 11 Notebook PC. *

Enabling Battery Safety Mode

1. When the BIOS installation completes, follow the instructions to restart your computer.

2. When the HP logo appears, press F10 to enter BIOS Setup.

3. Select 'System Configuration' tab using Right Arrow key. Look for the item "Battery Safety

Mode" and change the setting to "Enabled" using F5/F6 key.

4. Go to "Exit" Tab by Right Arrow Key and choose "Exit Saving Changes". Press the Enter key and

Select "Yes" in the dialog.

5. After system restart, the BIOS displays the following Message. Select "Accept".

6. After you restart your computer again, the battery will be put into Safety Mode.

7. You will be required to use your HP Power Adapter after accepting Battery Safety Mode.

Table of Contents

Do you have a question about the 11 and is the answer not in the manual?

Page 1 5. After system restart, the BIOS displays the following Message. Select "Accept". 6. After you restart your computer again, the battery will be put into Safety Mode. 7. You will be required to use your HP Power Adapter after accepting Battery Safety Mode. Disabling Battery Safety Mode...
Page 2 1. After the battery is replaced, turn on or restart the computer. When the HP logo appears, press F10 to enter BIOS Setup. 2. Select "System Configuration" tab using Right Arrow key. Look for the item "Battery Safety Mode" and change the setting to "Disabled" using F5/F6 key.