11 - 12 LI4278 Product Reference Guide
User-Programmable Supplementals
Supplemental 1: Parameter # F1h 43h
Supplemental 2: Parameter # F1h 44h
If you selected a Supplemental User-Programmable option from
page
11-9, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using
the numeric bar codes beginning on
3-digit prefix. Then select the 3 digits using the numeric bar codes beginning on
(zeroes).
UPC/EAN/JAN Supplemental Redundancy
Parameter # 50h
If you selected Autodiscriminate UPC/EAN/JAN Supplementals, this option adjusts the number of times to
decode a symbol without supplementals before transmission. The range is from two to thirty times. Five or
above is recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals. The
default is 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
NUMERIC BAR
CODES. Enter a leading zero for single digit numbers. To correct an error or change a
selection, scan
Cancel on page
UPC/EAN/JAN Supplemental Redundancy
page D-1.
Select User-Programmable Supplemental 2 to set a second
User-Programmable Supplemental 1
User-Programmable Supplemental 2
D-3.
Decode UPC/EAN/JAN Supplementals on
page D-1.
The default is 000
Appendix D,