Chapter 11 Symbologies; Introduction; Scanning Sequence Examples - Motorola LI4278 Product Reference Manual

CHAPTER 11 SYMBOLOGIES

Introduction

This chapter describes symbology features and provides programming bar codes for selecting these features.
Before programming, follow the instructions in
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the linear imager scanner powers down.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces do not merge.
Select a host type (see each host chapter for specific host information) after the power-up beeps sound. This is
only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan the
bar code menus, asterisks (

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to transmit bar code data
without the UPC-A check digit, simply scan the Do Not Transmit UPC-A Check Digit bar code under
UPC-A Check Digit on page
green, signifying a successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes. See the individual
parameter, such as Set Length(s) for D 2 of 5, for this procedure.
*
) indicate default values.
*
*
Enable UPC-A
Indicates Default
11-14. The linear imager scanner issues a fast warble beep and the LED turns
Chapter 1, GETTING STARTED.
Default Parameters on page
Feature/Option
(01h)
Option Hex Value
5-4. Throughout the programming
Transmit