Motorola LI4278 Product Reference Manual page 49

Scanner Beeper and LED Definitions (Continued)
Table 2-1
Beeper Sequence
Long low/long high/long
low/long high beeps
Parameter Programming
Long low/long high beeps
High/low beeps
High/low/high/low beeps
ADF Programming
Low/high/low beeps
High/low beeps
Low/low beeps
High/high beeps
High/low/low beeps
High/low/high/low beeps
Long low/long high beeps
Low beep
Low/high/high beeps
Long low/long high/long
low/long high beeps
Long low/long high/long
low beeps
Code 39 Buffering
High/low beeps
LED Indication
None
Red
Green
Green
None
Green
Green
Green Blinking
Green
Green
(turns off blinking)
Red
Green
Green
Red
Green
(turns off blinking)
None
Indication
Connection attempt was rejected by remote device.
Note: In the case of Pairing Methods on page
cradle may already be connected to another linear
imager scanner in single Point-to-Point locked mode, or
the piconet may be full in Multipoint-to-Point mode. If
Pair On Contacts is enabled and the linear imager
scanner that is inserted is already connected to the
cradle, no beeping occurs.
Input error, incorrect bar code or Cancel scanned,
wrong entry, incorrect bar code programming
sequence; remain in program mode.
Keyboard parameter selected. Enter value using bar
code keypad.
Successful program exit with change in the parameter
setting.
ADF transmit error.
Number expected. Enter another digit. Add leading
zeros to the front if necessary.
Alpha expected. Enter another alphabetic character or
scan the End of Message bar code.
ADF criteria or action is expected. Enter another criteria
or action or scan the Save Rule bar code.
All criteria or actions cleared for current rule, continue
entering rule.
Rule saved. Rule entry mode exited.
Rule error. Entry error, wrong bar code scanned, or
criteria/action list is too long for a rule. Re-enter criteria
or action.
Deleted last saved rule. The current rule is left intact.
All rules deleted.
Out of rule memory. Erase some existing rules, then try
to save rule again.
Cancel rule entry. Rule entry mode exited because of an
error or the user asked to exit rule entry.
New Code 39 data was entered into the buffer.
SCANNING 2 - 3
4-21, the