Motorola LI4278 Product Reference Manual page 175

To connect the USB interface:
Attach the modular connector of the USB interface cable to the host port on the bottom of the linear imager
1.
scanner cradle (see Connecting the CR0078-S/CR0008-S Series Cradle on page 1-8
CR0078-P Series Cradle on page
Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port
2.
of the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from
3.
On first installation when using Windows, the software prompts to select or install the Human Interface
4.
Device driver. To install this driver, provided by Windows, click Next through all the choices and click
Finished on the last choice. The cradle powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the linear imager
scanner cradle remain the same. Ensure you use the matching cable for the appropriate cradle.
If problems occur with the system, see
1-9).
Troubleshooting on page
USB INTERFACE
USB Device Type on page
Figure 8-1
3-4.
8 - 3
or Connecting the
8-5.
are examples