Chapter 11 Symbologies
Introduction
This chapter describes symbology features and provides programming bar codes for selecting these features.
Before programming, follow the instructions in
The scanner ships with the settings in the
Default Parameters
programming is not necessary.
To return all features to default values, scan the
If not using a Synapse or USB cable, select a host type. See the appropriate host chapter for specific host
information.
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to transmit bar code data without the
UPC-A check digit, scan the
UPC-A/UPC-E/UPC-E1 Check Digit on page
green, signifying a successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in the proper sequence.
See the individual parameter, such as Set Length(s) for D 2 of 5, for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Default Table on page 11-2
for all host and miscellaneous scanner defaults). If the default values suit your requirements,
Do Not Transmit UPC-A Check Digit
11-14. The scanner issues a short high beep and the LED turns
Chapter 1, Getting
Started.
Set All Defaults bar code on page
bar code listed under
(also see
Appendix A, Standard
4-3.
Transmit