Security; Phone Numbers - GE Simon XT User Manual

30 Simon XT TableTop Control Panel
User Manual
Initially, all user codes are blank. You can delete a user code by pressing Disarm while the code is being
changed.
Duress code. The duress code, when used in place of another user code, generates a silent duress alarm
which is reported to the central monitoring station.
To change the duress code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to Duress code, then press Enter.
4. The current value of the code now flashes. Enter a new code (use correct length), then press Enter.
5. Press Status repeatedly to exit.
Initially, the duress code is blank. You can delete the duress code by pressing Disarm while the code is
being changed.

Security

The Security menu contains the download enable option. This option determines whether your dealer can
access the system remotely.
To program the download enable option, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Security, then press Enter.
3. Scroll up/down to Download enable, then press Enter.
4. The current value of this option now flashes. Scroll up/down to toggle this option on/off, then press
Enter.
5. Press Status repeatedly to exit.

Phone numbers

Phone #4 is the only system phone number that you can change. Therefore, it is often used for voice reporting
of alarms to your phone, if it was programmed for this purpose by the installer.
To change Phone #4, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Phone #s, then press Enter.
3. Scroll up/down to Phone #4, then press Enter.
4. The first digit of the current value of this option now flashes (this may take up both lines on the
display). Change each digit of the phone number by scrolling or entering a numerical value, then move
to the next digit by pressing Enter.
5. When done, press Enter again to save the new phone number.
6. Press Status repeatedly to exit.