SMART Board Board X800i4 Configuration And User's Manual page 52

C H A P T E R 5
Maintaining your interactive whiteboard system
5. Without applying pressure to the boom, replace and tighten the cover screw until it's secure.
6. Connect all cables to the projector, and then replace the cable cover.
7. Connect the power cable to a power outlet.
8. Press the Power
operating and that the lamp module is correctly installed, and then wait for the projector to turn
on completely.
The ECP's Power light turns solid green when the system starts.
9. Wait five minutes for the projector to warm up.
N
N O T E
You might need to adjust the projected image after you perform the previous procedures. For
more information, see the included SMART Board X880i4 and X885i4 Interactive
Whiteboard System Installation Guide (smarttech.com/kb/149615) and Adjusting the image
on page 22.
42
button once on the remote control or ECP to confirm that the projector is