SMART Board Board X800i4 Configuration And User's Manual page 26

C H A P T E R 3
Using your interactive whiteboard system
I
I M P O R T A N T
There are no projector menu options on the ECP. Keep your remote control in a safe place because
the ECP is not meant to substitute for the remote control.
Setting Use
Image Adjustment menu
Display Mode Indicates the projector's display output
(SMART Presentation, Bright
Room, Dark Room, sRGB and
User).
Brightness Adjusts projector brightness from 0 to
100.
Contrast Adjusts the difference between the
lightest and darkest parts
of the image from 0 to 100.
Frequency Adjusts the display data frequency of
the projected image from -5 to 5 to
match the frequency of your
computer's graphics card.
Tracking Synchronizes your projector's display
timing with your computer's graphics
card from 0 to 63.
H-position Moves the projected image's horizontal
position left or right from 0 to 100.
V-position Moves the projected image's vertical
position up or down from -5 to 5.
Saturation Adjusts the projected image's color
saturation from 0 to 100.
Sharpness Adjusts the projected image's
sharpness from 0 to 31.
16
Notes
The default is 0.
This setting applies to VGA inputs
only.
This setting applies to VGA inputs
only.
Don't adjust this setting unless you're
advised to by a certified SMART
Support specialist
(smarttech.com/contactsupport).
You can apply this setting only after
you make all boom adjustments.
This setting applies to VGA inputs
only.
Don't adjust this setting unless you're
advised to by a certified SMART
Support specialist
(smarttech.com/contactsupport).
You can apply this setting only after
you make all boom adjustments.
This setting applies to VGA inputs
only.
This setting applies to S-video and
composite video inputs only.
This setting applies to S-video and
composite video inputs only.