Lowering Antenna To Travel Position - Winegard RM-DM46 Owner's Manual & Installation Instructions

Rv digital satellite system with digital elevation sensor
Hide thumbs Also See for RM-DM46:
Table of Contents

Advertisement

TUNING ANTENNA
STEP 1. Your receiver should indicate it is receiving a signal. To tune your
antenna for the best signal strength, slowly move the antenna left, then
right until you have found the position that gives the highest signal strength.
It is important to turn the antenna slowly; since the signal is digital the
receiver takes a few seconds to lock on.
STEP 2. Place rotation clamp in the LOCK position. This prevents the
antenna from moving and losing the signal.
STEP 3. Slowly raise, then lower the antenna until you have peaked the
signal. You are now ready to watch satellite TV!

LOWERING ANTENNA TO TRAVEL POSITION

STEP 1. Set rotation clamp to the ROTATE position.
STEP 2. Rotate antenna until pointer on directional handle aligns with
the red screw on the rotation clamp.
STEP 3. Turn elevating crank (counter clockwise) in direction of "DOWN"
arrow until resistance is met. The number of turns will vary according to
the elevation angle the antenna was set to.
STEP 4. Move rotation clamp to the LOCK position. Antenna is now
locked in travel position.
DO'S
1. Do check parking location for obstructions before raising antenna.
2. Do carefully raise, lower and rotate — if difficult, check for cause.
3. Do rotate slowly when searching for the satellite(s) and check fine tuning
on TV set to make sure it is properly adjusted.
4. Do lower antenna before moving vehicle.
5. Activate programming by calling programming service for your receiver.
DON'T'S
1. Don't move RV/coach with the antenna in the UP position. This will
VOID your warranty. This may also cause damage to your roof.
2. Don't force elevating crank up or down. Check for cause of trouble.
3. Don't rotate directional handle hard against stops.
4. Don't apply paint over top of base plate or anywhere on lift.
5. Don't apply sealing compound on gear housing.
STEP 5. Snap elevation crank into place.
CAUTION: NEVER LOWER ANTENNA IN ANY POSITION
EXCEPT TRAVEL POSITION.
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rmfldm4Rm-dm00Rm-dm04

Table of Contents