Winegard RM-DM46 Owner's Manual & Installation Instructions page 9

CAUTION:
After INITIAL INSTALLATION,
the antenna SHOULD ROTATE
APPROXIMATELY 360°FROM
TRAVEL POSITION.
The pointer on the
DIRECTIONAL HANDLE
should point towards the RED
SCREW ON THE ROTATION
CLAMP when in TRAVEL
POSITION.
ASSEMBLED VIEW
Rotation
Clamp
Red Screw
POINT TO
BACK OF RV
Pointer must
point to RED
SCREW at
CENTER OF
ROTATION
CLAMP when in
travel position.
CAUTION:
The antenna MUST BE IN THE
TRAVEL POSITION before
ALIGNING the Directional
Handle and Ceiling Plate.
Tighten screw snugly
FIGURE 13
Flat Washer
Nut for
threaded tube
Elevating Shaft
Threaded Tube
3 Directional
Handle Extension
1 Ceiling Plate
2 (4) #10 Phillips Flat
Head Screws
4 Directional
Handle
ALIGN POINTER
WITH ANTENNA
TRAVEL POSITION
5 ELEVATING
CRANK HANDLE
(When installed,
extends 2-1/4"
from ceiling).
Snap Handle
into base
when not in use.
9