Connect Satellite Antenna To Satellite Interface; Connect Satellite Interface To Primary Hd Receiver - Winegard WB-2000 Installation & Operation Manual

3.4 Connect Satellite Antenna to Satellite Interface

DC OUT
TO SAT
ANTENNA
DC IN
Locate the primary coax cable from roof top antenna. Connect it to "Sat Antenna In" on the BLK/RED
Satellite Interface. See Figure 3.6.
Figure 3.6
DC OUT
TO SAT
ANTENNA
DC IN
BLK/RED

3.5 Connect Satellite Interface to Primary HD Receiver

Depending on your satellite service provider, you must connect the Satellite Interface to
your primary HD receiver in 1 of 2 ways. The DirecTV installation begins on the next
page. See page 11 for Dish Network and Bell ExpressVU installation.
SAT.
FACTORY SAT.
COMM. OUT 1
RECEIVER ANTENNA
HD HD USE
TO SAT.
ONLY OUT IN
CTRL 2 CTRL 1
ANTENNA
COMM. OUT 1
HD
HD
TO SAT.
CTRL 1
CTRL 2
ANTENNA
SAT.
SAT.
FACTORY
RECEIVER ANTENNA
USE
IN
ONLY OUT
The primary coax ca-
ble is connected to the elec-
tronics board inside of the
dome. In most antennas,
the secondary coax must be
connected to the second-
ary coax port inside of the
dome. See the manual for
more information.