KVH Industries FB250 User Manual page 233

• <Max bitrate DL> is the maximum bit rate down link (0, 8, 16, 32, 64, 128,
256)
• <Guaranteed bitrate UL> is the guaranteed bit rate up link (0, 8, 16, 32, 64,
128, 256)
• <Guaranteed bitrate DL> is the guaranteed bit rate down link (0, 8, 16, 32,
64, 128, 256)
Example: AT+CGEQMIN=1,1,64,64,64,64
AT+CGTFT
Usage:
AT+CGTFT is the Traffic Flow Template (TFT). This command is needed if a
secondary PDP context needs to be opened. The TFT specifies which IP traffic
should run through which PDP context.
Syntax:
AT+CGTFT=<cid>,<packet filter identifier>,<evaluation precedence index>,
<source address and subnet mask>,<protocol number>,<destination port
range>,<source port range>
• <cid> is the Context Identifier (1 – 11)
• <packet filter identifier> is the packet filter identifier (1 – 8)
• <evaluation precedence index> This filter's Evaluation Precedence Index
(0-255)
• <source addr & subnet> is (0.0.0.0.0.0.0.0-
255.255.255.255.255.255.255.255)
• <protocol number> is the protocol number (0-255)
• <destination port range> is Destination Port From.To (0.0-65535.65535)
• <source port range> is Source Port From.To (0.0-65535.65535)
Example: AT+CGTFT=1,1,0,87.48.134.251.255.255.255.0,6,20.21,1024.65535
Supported AT commands for PPPoE
Chapter 5: Troubleshooting
219