KVH Industries FB250 User Manual page 119

2. For each Phone/Fax port, set the call type for incoming and outgoing calls.
Note
Port 1 is the connector closest to the antenna connector, and Port
2 is the connector closest to the ISDN connector.
The call types are described in more detail in Selecting the call type on
page 44.
For Incoming calls, you can select Standard or 3.1 kHz Audio or both.
•
If you select both, any device connected to the Phone/Fax interface will
react (ring) on incoming calls.
If you select e.g. Standard, the Phone/Fax interface will only react on
calls made to the Standard phone number.
For Outgoing calls, you can select either Standard or 3.1 kHz Audio. The
•
selected type will be used by default, if possible, for any outgoing call.
Note, however, that fax machines must use 3.1 kHz Audio.
Note
You can override the default setting for outgoing calls by dialing
1* (force the call to Standard) or 2* (force the call to 3.1 kHz
Audio) before the number. For further information, see
Overriding the default outgoing call type on page 45.
3. Click Apply.
Chapter 4: Using the web interface
Setting up the interfaces 105