Supported At Commands For Pppoe - KVH Industries FB250 User Manual

Supported AT commands for PPPoE

Overview of supported AT commands
You can use PPPoE to issue AT commands to the terminal, for example
specifying Quality of Service parameters or which APN to use.
The following AT commands are supported:
• AT+CGDCONT
• AT+CGEQREQ
• AT+CGEQMIN
• AT+CGTFT
• AT+CGDSCONT
Functions of the supported AT commands
AT+CGDCONT
Usage:
AT+CGDCONT is used to specify the Context parameters such as which APN the
context must use.
This can be used to specify a specific APN different from the one on the SIM
card.
Syntax:
AT+CGDCONT=<cid>,<protocol>,<APN>
• <cid> is the Context Identifier (1 – 11)
• <Protocol> is the transport protocol (IP or PPP)
• <APN> is the Access Point Node
• <PDP Addr> is the static IP address from APN (NOT USED!)
Example: AT+CGDCONT=1,ip,"bgan.inmarsat.com"
Supported AT commands for PPPoE
Chapter 5: Troubleshooting
217