Connecting The Cables To The Baseboard - Fujitsu PRIMERGY RX900 S2 Upgrade And Maintenance Manual

6.4.11 Connecting the cables to the baseboard

Figure 47: Connecting the cables to the baseboard
Ê Connect the following cables to the baseboard:
– SAS backplane cable (1)
– Signalling cable (2) and power cable (3) to the optical drive
– Front video connector cable (4)
– Front USB cable (5)
– Control panel cable (6)
– Chassis ID cable (7)
– Power cable to the SAS backplane (8)
– Chassis ID board cable (9)
For the cable plan see
RX900 S2
"Cabling" on page
Upgrade and Maintenance Manual
Hard disk and solid state drives
370.
97