Fujitsu PRIMERGY RX900 S2 Upgrade And Maintenance Manual page 50

Basic procedures
V
CAUTION!
Due to the heavy weight, a suitable lifter is required to lift the server
to the mounting position. Make sure that the lifter is locked in place
before you start to mount the server.
Ê Insert the inner parts of the rails that are mounted on the server into the
protruding middle parts until the rails engage (2).
Ê Release the locking mechanism of both rails (3).
– Left side oft the server: Push upwards
– Right side of the server: Push downwards
Ê Lower the lifter platform and slide the server into the rack (4). Remove the
lifter.
V
CAUTION
Do not use the front handles to raise the server as they are not designed
to bear the weight of the unit. The front handles are only to be used for
pushing the server into the rack or pulling it out of the rack.
Sliding the Server into the rack
Ê Slide the server into the rack.
Ê Fasten the server to the rack with the four knurled screws on the front panel
and the cage nuts, see (5) in
Ê Route the cables as described in the Technical manual for the rack in
question.
50
figure 10.
Upgrade and Maintenance Manual
RX900 S2