Removing The Usb Board - Fujitsu PRIMERGY RX900 S2 Upgrade And Maintenance Manual

6. Remove all CPUMEMRs, see
I
Before removing the CPUMEMRs, take a note on the installation
slot number for each CPUMEMR. Make sure that you reinstall the
CPUMEMR in the slot it was located before the replacement.
7. "Removing the control panel" on page 229
8. "Removing the front panel module" on page 234

12.3.3 Removing the USB board

Figure 146: Removing the USB board from the front panel module
Ê Remove both screws (see circle).
Ê Push the USB board backward out.
RX900 S2
"Removing the CPUMEMR" on page 190
Upgrade and Maintenance Manual
Front panel and external connectors
239