Expansion Cards And Bbu - Fujitsu PRIMERGY RX900 S2 Upgrade And Maintenance Manual

8

Expansion cards and BBU

Authorized personnel
Authorized specialist personnel can carry out replacement tasks for
integral server components. Ask you local Fujitsu service center for
more detailed information.
V
CAUTION!
Procedures indicated as "Authorized personnel only" must be
done by Fujitsu service personnel or technicians trained by
Fujitsu for doing these tasks. Please note that unauthorized
interference with the system will void the warranty and exempt
the manufacturer from all liability.
I
The number and location of available PCIe slots depends on the
CPUMEMR configuration. Make sure that the planned CPUMEMR
configuration enables you to use the PCIe slots needed for the individual
use case of the server.
For detailed information on configuration rules and supported expansion
card types see "Baseboard D3144, CPUMEMR D3145, PCIR D3146 for
PRIMERGY RX900 S2 Technical Manual" or in the configurator using
the following link:
http://ts.fujitsu.com/products/standard_servers/rack/primergy_rx900s2.html
(for the EMEA market).
Figure 52 shows the PCIe slot configuration. Expansion cards can be installed
in the PCIe slots on the PCI Riser (A) and on the baseboard (D). The PCI Riser
is connected to the baseboard via the connectors C and E.
The PCIe slots are assigned as follows:
B: non-hot plug PCIe slots on the PCI Riser
F: non-hot plug PCIe slot for the Modular Raid controller only
G: hot-plug PCIe slots
H: non-hot plug PCIe slots on the baseboard
RX900 S2
Upgrade and Maintenance Manual 105