USB INTERFACE
User's Manual
Cable
This printer supports the USB 1.1 Full speed specification. To connect
to the host, use USB 2.0-compliant INF cables (5 meters (196 inch) or
shorter). (Use the shielded cables.)
Connector pin alignment
- Connector specification
Printer side
Cable side
Specification
- Basic specification
Note
It does not guarantee all operations on hosts.
- Power control
- Transmission mode
INTERFACE INFORMATION
No.
Signal line name
1
vbus
2
D-
3
D+
4
GND
Shell
Shield
Type B receptacle (female)
Upstream port
Type B plug (male)
USB interface compliant
Self-power device
Full speed (Maximum 12 Mbps
+0.25%)
Function
Power supply
Data transfer
Data transfer
Signal ground
D-11