Points To Remember; Printing A List Of Selected Options(Led) - Fujitsu DL7600 User Manual

PRINTING A LIST OF
SELECTED
OPTIONS(LED)
<< FUNCTION >>
SAVE&END MENU1
HEX-DUMP V-ALMNT
User's Manual

Points to Remember

•
Whenever you enter setup mode, short help menus are printed at
the top of the page. Help menus are also printed when you select
the SELF-TST, HEX-DUMP, or V-ALMNT functions.
Use help menus for quick reference while in setup mode.
•
When printing the items and options for each function, you can
only print one item at a time. However, you can move either
forward or backward in the item list. To move forward (print the
next item), press the
previous item), press the
•
While in the <<FUNCTION>> menu or when selecting a
function that contains items and selectable options, press the
ONLINE button to reprint the <<FUNCTION>> menu.
•
A short underline under the first two letters of an option
indicates that it is the current default setting. For example, 12
CPI indicates that 12 characters per inch is the default pitch.
To change the default, select and save a new pitch setting.
•
While in setup mode, you can use the LIST function to print out
a list of the currently selected options (see the next section for
details).
•
To exit setup mode and permanently save your changes, select
the SAVE & END function. For details, see the section Exiting
and Saving later in this chapter. To exit setup mode without
saving your changes, turn the printer off. Your previous power-
on defaults are active when you turn the printer on again.
The LIST function prints a list of all the printer's currently selected
options. This function is useful for checking the printer settings when
you first enter setup mode or just before you exit. To print a list of
options, load continuous forms paper and then proceed as follows:
1. Enter setup mode.
Press the AUTO GAP button and the HI IMPACT button
simultaneously until the printer beeps. Wait for the printer to
stop printing and check that the following <<FUNCTION>>
menu is printed:
MENU2 HARDWRE ADJUST
INITIAL
button. To move backward (print the
button.
CONFIG GAP-ADJ DEFAULT
USING SETUP MODE
LIST SELF-TST
5-7