Download Print this page

Fujitsu DL7600 User Manual: Procedure (for Lcd Type)

Hide thumbs

Advertisement

USING SETUP MODE
<< FUNCTION >>
SAVE&END MENU1
MENU2
HEX-DUMP V-ALMNT
INITIAL
5-54
HARDWRE
ADJUST
CONFIG
2. Select the DEFAULT function (LED type).
Repeatedly press the "TEAR OFF" or "LOAD" button to
position the cursor on the left edge of the aluminum print guide
on DEFAULT. Press the
DEFAULT function. The printer reprints the <<FUNCTION>>
menu. The default values in MENU1 and MENU2 are now reset
(not saved yet).
3. Save reset values (LED type).
To exit setup mode and save the new defaults, make sure that
the cursor on the left edge of the aluminum print guide are
positioned on SAVE & END, then press the
or the
MICRO button.

Procedure (for LCD type)

To reset the factory defaults in MENU1 and MENU2, select DEFAULT
in SETUP mode. Detail of method as follows:
1. Enter setup mode (LCD type).
Press the SETUP button at offline state. Check that the "SETUP
MODE" is displayed on LCD panel.
2. Select the DEFAULT function (LCD type).
Repeatedly press the " " or " " button to display "SUB
FUNCTION". And then press the" " button to move lower layer.
And then repeatedly press the " " or " " button to display
"DEFAULT". And then press the "SELECT" button to reset the
default values in MENU1 and MENU2 (not saved yet).
3. Save reset values (LCD type).
Exit setup mode, saving the factory defaults.
Push SAVE/EXIT button. Check that " :SAVE :CANCEL" is
displayed on LCD panel. Then press the" " button.
GAP-ADJ
DEFAULT
LIST
button or the
button to select the
SELF-TST
MICRO button
User's Manual

Advertisement

   Also See for Fujitsu DL7600

   Related Manuals for Fujitsu DL7600

Comments to this Manuals

Symbols: 0
Latest comments: