Loading Continuous Forms (Front Feed) - Fujitsu DL7600 User Manual

PAPER HANDLING
3-12

Loading Continuous Forms (Front Feed)

This section explains how to use continuous forms as the tractor unit is
installed at the front of the printer. The tractor unit pushes continuous
forms. This condition applies when you first purchase the printer.
Up to 8-ply media can be fed by the front tractor unit.
You can use continuous forms paper even if you have a cut sheet feeder
installed at the rear of the printer.
To load continuous forms paper:
1. Make sure that the printer is turned on. Remove any single-sheet
paper from the printer.
2. Lift up the soundproof cover as shown below.
3. Release the tractor locking levers by pulling them up(①). Open
the tractor paper holders. See the following figure(②).
4. Position the tractors and center guide.
5. Fit the paper feed holes onto the left and right tractor pins.
Adjust the right tractor to the width of the form. Close the paper
holders.
Paper Holders
Set the continuous forms to front tractors
Center Guide
Locking Levers
Paper Holders
User's Manual