Table of Contents
Advertisement
Rebuild Wizard
If there are multiple arrays defined, you must select the proper Array #. Press
Next button to proceed to Step 2 of Rebuild Wizard or Cancel button to stop.
In Step 2 above, you must select the Target drive which will receive data. Make
sure you select the blank new or replacement drive. The unselected drive will
contain "good" data. It will be the remaining working drive of an array, or a
system drive containing existing data that you wish to mirror. Make absolutely
sure and double-check which drive is which. If data exists on the target drive, it
will be over-written.
Click the Next button to proceed to Step 3 or Cancel button to stop.
TM
FastCheck
Monitoring Utility
1
2
5-8
Advertisement
Table of Contents
Troubleshooting
