Getting Started; Unpacking Your Fasttrak66 - Promise Technology FastTRAK66 User Manual

Chapter 2
This section is designed to get you started for installation of your FastTrak66.
Unpacking Your FastT rak66
When you receive the FastTrak66, the package should contain the items listed
below:
FastTrak66 Ultra ATA/66 RAID Card
FastTrak66 User's Manual
Registration Card
FastTrak66 Driver floppy diskette
Two Internal 80-wire/40-pin Ultra ATA/66 hard drive cables (18" length)
Before installing the adapter into an existing system, backup any necessary data.
Failure to follow this accepted PC practice could result in data loss.
Power off the system. Be careful when handling the controller. The FastTrak, like
any valuable part of your computer system, is susceptible to static electricity. Be
sure you are well grounded for the installation.
If ANY of the contents are missing or appear to be damaged, please contact your
dealer or distributor immediately.
Board Layout
IDE 2

Getting Started

CAUTION IN HANDLING AND INSTALLING!
IDE 1
Connectors
First IDE channel
Second IDE channel
4-pin LED connector:
Pin1PWR, Pin2 GND,
Pin3 GND, Pin4 PWR
IDE 1
IDE 2
LED
21-1-1