Microsoft Windows 3.1X; Windows 95/98 Driver - Promise Technology FastTRAK66 User Manual

Microsoft Windows 3.1x

The Windows 3.1x operating systems are supported by the FastTrak66 onboard
BIOS. No additional drivers are required. Once the card is installed and the system
rebooted, proceed with partitioning/formatting each FastTrak66 disk array as if it
were a physical drive.
Microsoft Windows95/98 driver
Windows95/98 setup will show a "New Hardware Found" dialog box. Under ver-
sions Win95 4.00.950 and 4.00.950A an "Unknown PCI Device" will be detected.
Under Win95 v. 4.00.950 B and Win98 "PCI RAID Controller" will be displayed.
NOTE: To check the Windows95/98 version number, click the Control Panel from
My Computer followed by the System icon. Under "System:" note the version
number.
1) In the dialog box choose "Driver from disk provided by hardware manufac-
turer" button.
2) In the A: drive, insert the FastTrak66 utility diskette and type in "A:\WIN9x"
when prompted for the directory.
3) Select "Promise Technology, Inc. PCI FastTrak66 Driver" and click on Next.
The FastTrak66 driver is now copied onto the system and entered into the
Windows95/98 driver database.
4) When the "System Settings Change" dialog box appears, remove the floppy
diskette and click on "Yes" to restart the system. Windows95/98 will then
restart for the driver installation to take effect.
Confirming Windows95/98 Installation
1) From Windows95/98, open the Control Panel from My Computer followed by
the System icon.
2) Choose the "Device Manager" tab and click the "+" in front of the "SCSI
Controllers" hardware type.
3) The driver "Promise Technology, Inc. PCI FastTrak66 Driver" driver should
be installed.
Operating System Installation
7-2