Quick Installation - Promise Technology FastTRAK66 User Manual

Quick Installation

This section is designed to get you started for quick installation of your FastTrak66.
Use drives that are preferably the same model and capacity. NOTE: If using older
IDE drives (less than 300MBs), check with the manufacturer if it supports Multi-
DMA transfers.
[ 1 ] Install FastTrak66 and Drives
Power off the system and ground yourself by touching exposed metal of the PC
chassis.
Connect 18" 80-wire/40-pin cables to the FastTrak66 and hard disk drives. Make
ter/slave jumper settings recommended by
the drive manufacturer. When 2 drives are
attached, configure each drive as a master
(with no slave attached) and each drive on
a separate channel. Check drive instruc-
tions for details on Master & Slave settings.
Attach the case LED 2-pin or 4-pin cable
to the FastTrak66 4-pin
power/ground connector labeled LED. Be sure to align pin 1 of the
LED cable to pin 1 of the connector.
1
LED
Insert and secure the FastTrak66 into an open PCI slot. Re-check
cabling for proper connection.
Quick Installation
sure the blue plastic connector is used for
the FastTrak66 slots. Attach the darker con-
nectors to the drives. Note that the colored
cable edge indicates Pin 1.
Jumper and install the drives with proper
mas-
Total Drives
FastTrak66 Drive Setup
IDE 1
One
M
Two
M
Three
M & S
Four
M & S
IDE 2
----
M
M
M & S
2-2