Table of Contents
Advertisement
This section is designed to quickly get your FastTrak TX2000 controller up and running using
the default settings, which will be optimal for most users. If you wish to modify any of the default
settings, please refer to page 14, Using FastBuild™ Configuration Utility.
Unpacking Your FastTrak TX2000
When you receive the FastTrak TX2000, the package should contain the items listed below:
FastTrak TX2000 Ultra ATA/133 RAID Card
FastTrak TX2000 User Manual
FastTrak TX2000 Driver floppy diskette
Promise Array Management (PAM) utility floppy diskettes
PAM User Manual
Two internal 80-wire/40-pin Ultra ATA/133 hard drive cables (18" length)
If ANY of the contents are missing or appear to be damaged, please contact your dealer or
distributor immediately.
WARNING: Before installing the adapter into an existing system, backup any
necessary data. Failure to follow this accepted PC practice could result in data
loss.
NOTE: FastTrak TX2000, like every other valuable part of your system, is
subject to static electricity. Be sure that you're properly grounded (Promise recommends that
you wear an anti-static strap, or touch a grounded object), and that your system is unplugged
before installing FastTrak TX2000.
FastTrak TX2000™ Series User Manual
Quick Start
5
Advertisement
Table of Contents
