Fcc Compliance - Peco WavePRO K2500-001 Operating Manual

FCC COMPLIANCE

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Warning: Modifi cations not expressly approved by the manufacturer could void the user's authority to operate the
equipment under FCC rules. NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
© Copyright 2010. PECO, Inc. All Rights Reserved. P/N 70161 3220-2216 REV 0
PECO is a registered trademark of PECO, Inc. The PECO logo is a trademark and/or service mark of PECO, Inc.
Automation and Controls
Division of PECO, Inc.
PO Box 82189, Portland, OR 97282
Phone: 503-233-6401
Email: sales@pecomanufacturing.com
www.pecomanufacturing.com
24