Peco WavePRO K2500-001 Operating Manual page 13

THE T2500 DISPLAY MENUS (CONT.)
Program Override Commands
7
HOLD – Indicates thermostat is in a Temporary or Permanent Hold.
(Programmed settings are off, but they are not lost.)
HOLD HRS – During programming, lights up in conjunction with clock digits; allows
program to be put on Temporary Hold for up to 24 hours.
HOLD DAYS – During programming, lights up in conjunction with the clock digits; allows
program to be put on Temporary Hold for up to 99 days.
HOLD ON – Turns the Permanent Hold on. The current setpoint is maintained indefi nitely
or until the Permanent Hold is turned off.
HOLD OFF – Turns the Permanent Hold off and resumes programmed settings.
Service Indicator
8
The wrench symbol will fl ash during wireless pairing. For further information, see "Establish
a wireless connection" in the "WavePRO Wireless System Installation Guide." The wrench
symbol is displayed when there is a temperature sensor error. The wrench symbol also
indicates there is an open or a short connection to the sensor. When this occurs, the
T2500 thermostat will disable all outputs and illuminate the wrench symbol. A service
technician should be called to determine the cause of the error.
13