Honda 08B26-S5T-1000-91 Installation Instructions Manual page 7

24. Remove the left rear bulkhead cover:
• Remove the clip from the left rear bulkhead
cover. Take care not to damage the clip.
• Gently pry the left rear bulkhead cover away
from the left rear side trim panel by inserting
the end of a flat-tip screwdriver wrapped in a
shop towel into the groove of the left rear
bulkhead cover.
• Pry up on the seven retaining tabs, and remove
the left rear bulkhead cover. Take care not to
damage the retaining tabs.
LEFT REAR SIDE
TRIM PANEL
25. Remove the clip that fastens the left rear side
trim panel. Take care not to damage the clip.
LEFT REAR SIDE
TRIM PANEL
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
GROOVE
FLAT-TIP
SCREWDRIVER
CLIP
LEFT REAR
BULKHEAD
COVER
RETAINING
TAB
CLIP
SEAT BELT
LOWER ANCHOR
BOLT
32 N·m (24 lb-ft)
26. Remove the left rear seat belt lower anchor bolt.
27. Remove the rear trim panel (three clips and two
hooks).
HOOK
28. Remove the two upper screws and the rear lower
clip from the left rear side trim panel.
UPPER SCREW
REAR LOWER CLIP
29. Carefully pull the left rear side trim panel away
from the body without creasing it.
AII 27936 (0408)
CLIP
REAR TRIM
PANEL
LEFT REAR
SIDE TRIM
PANEL
7 of 14