Configuration Information - Factory Integrated Models; Step 1: Base Configuration - HP ProLiant DL580 Generation 5 (G5) Quickspecs

Generation 5

Table of Contents

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are

NOTE:

ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on

configurable product offerings and requirements.

NOTE:

NOTE: Configure-to-order (CTO) servers must start with a CTO Chassis.

NOTE:

NOTE: FIO indicates that this option is only available as a factory installable option.

NOTE:

HP Models

Step 2: Choose Required Options (only one of the following from each list unless otherwise

noted)

HP Processors

HP ProLiant DL580 G5 highly serviceable rack chassis

NOTE: 487381-B21 is for use when configuring the DL580 with 7400 series

NOTE:

processors.

HP ProLiant DL580 G5 highly serviceable tower chassis

Factory Integrated Model ships with:

Two embedded NC373i Multifunction Gigabit Server Adapters

Eight standard PCI-express slots

HP Smart Array P400i Controller

Two hot-plug power supplies with two high-line IEC power cords

Six (6) redundant hot-plug fans

SFF SAS/SATA drive cage

HP Integrated Lights-Out 2 management processor: integrated on system board

tower or rack (4U), 7-inch

Intel® Xeon® X7460 2.67GHz Hexa Core 16MB DL580 G5 Factory Integrated

Processor Option Kit