Subscribe to Our Youtube Channel
Related Manuals for Clarke X-PRO CAT170
Summary of Contents for Clarke X-PRO CAT170
- Page 1 NEEDLE SCALER MODEL NO: CAT170 PART NO: 3120187 OPERATING & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0417...
-
Page 2: Specification
INTRODUCTION Thank you for purchasing this CLARKE Needle Scaler. Please read all of the safety and operating instructions carefully before using this product. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: General Safety Rules
GENERAL SAFETY RULES CAUTION: FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN PERSONAL INJURY, AND/OR DAMAGE TO PROPERTY. WORK ENVIRONMENT 1. Keep the work area clean and tidy. 2. Dress appropriately - Do not wear loose clothing or jewellery. Tie long hair out of the way. -
Page 4: Transport And Storage
• Moving to another work area. • Passing the tool to another person. 10. Never use the tool if it is defective or operating abnormally. 11. This tool should be serviced at regular intervals by qualified personnel. 12. Avoid damaging the tool by applying excessive force. 13. -
Page 5: Compressed Air Requirements
• A typical air line layout is shown above. If an automatic in-line filter/ regulator is used, it will keep the tool in good condition, but should be regularly checked and topped up with oil. clarke airline oil should be used, and the lubricator adjusted to approx 2 drops per minute. -
Page 6: Before Use
BEFORE USE ASSEMBLING THE NEEDLE HOLDER The needle scaler is packed in two halves. • The main body and hammer assembly • The needles with needle holder, needle tube and spring 1. Insert the needles, needle holder and spring into the needle tube, Ensure the needle holder is the correct way round, so that the heads of the needles sit snugly in the recesses in the holder. -
Page 7: Disconnecting The Air Supply
4. Turn on the air supply and check for air leaks. Rectify any found before proceeding. • PTFE tape may be useful for sealing threaded connections. 5. If required, connect an in-line mini oiler to the tool. • A mini oiler helps to prolong the life of the air tool. 6. -
Page 8: Maintenance
STORAGE If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of Clarke air-line oil into the air inlet and depress the trigger in order to lubricate the internal parts. When not in use, the needle scaler should be disconnected from the air supply and stored in a dry place out of the reach of children. -
Page 9: Troubleshooting
ACCESSORIES AND CONSUMABLES A wide range of accessories is available including filter/regulators, lubricators, high-pressure hoses (5 to 50 metres) etc. Contact your Clarke dealer for further information or the Clarke International Service Department. Replacement 19-piece Needle Set;- CAT172 (Clarke part no; 3120189). -
Page 10: Component Parts
COMPONENT PARTS Description Description Main Body Front Valve Block O-Ring Piston O-Ring Barrel Sleeve Throttle Valve Nose Spring Gasket Gasket Barrel Assembly Valve Cap Driver Retainer Retainer Buffer Throttle Lever Retainer Clip Hose Adaptor Needle Driver Locking Ring Needle (19) Alignment Shim Needle Holder Rear Valve Block... -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the X-PRO CAT170 and is the answer not in the manual?
Questions and answers