Controlling An Ipod - Crestron Adagio AES Operation Manual

Crestron Adagio™ AES
Find the iPod Controls
Operations Guide – DOC. 6456B
Change PIN Controls
SOURCE
ROOM
HOUSE
MENU
Enter the first digit of the PIN by turning the selection knob
clockwise or counterclockwise until the desired digit is
displayed.
Press the soft buttons labeled < or > to move the cursor to the
previous or next digit and enter the rest of the PIN.
When the new PIN is displayed, press the soft button labeled
ENTER to open the Setup controls. To cancel, press the soft
button labeled Cancel.
⇒
To reset the Personal Identification Number (PIN) to the factory
default (1234):
Press and hold the left-most and right-most soft buttons. After
approximately three seconds, the display will indicate that the
PIN has been reset to the factory default.
Press the soft button labeled OK.
⇒
Press the MENU button to return to the SIRIUS Radio controls.

Controlling an iPod

An Apple iPod can be controlled from the AES front panel with an optional
CEN-IDOC Interface for Apple iPod
The following assumes that the CEN-IDOC has been installed and an iPod has been
connected as described in the CEN-IDOC guide.
•
Place the AES in the Source mode (refer to "Select a Source" on page 37).
•
Turn the selection knob to the iPod source (source #5). The playback status,
current track, and artist playing on the iPod will be displayed.
iPod Source
B
SOURCE
ROOM
HOUSE
MENU
Control
•
Press the soft button labeled Control to open the iPod controls.
Entertainment System
Current PIN: 1234
Enter New PIN
1234
S2 SIRIUS
Cancel <
®
.
Source 5
Oh, Pretty Woman
Roy Orbison
Entertainment System: Adagio AES • 51
BKLT
SCHED
DISPLAY
MORE
> Enter
BKLT
SCHED
DISPLAY
MORE