Crestron Adagio AES Operation Manual page 26

Entertainment System
Room & Preset Group Button
Labels
22 • Entertainment System: Adagio AES
AES MODEL
AES
(US & Canada)
AESI
(International/230VAC)
•
Insert the fuse holder into the AES.
•
Push in the fuse holder with a flat head screwdriver. While pushing in the
fuse holder, turn the screwdriver clockwise until the fuse holder sinks in.
•
Push in the fuse holder a little further and turn the screwdriver clockwise
until the fuse holder locks in place.
•
Connect power to the AES.
Use Adagio Composer or Crestron Engraver software to create and print custom
labels on overhead transparency film for the AES' room buttons and preset group
buttons.
NOTE: When printing custom labels, some experimentation may be required for
optimum results.
Custom-engraved labels can also be ordered from Crestron. Contact Crestron for
more information.
To remove the label:
1. Remove the label cover with a small, flat-head screwdriver. The label cover
is magnetically attached to the front panel of the Adagio component. The
label strip will be exposed.
2. Insert the screwdriver behind the label strip as shown in the diagram below.
Crestron Adagio™ AES
REQUIRED FUSE TYPE
T8AH (¼" x 1¼", 250V, 8A,
time-lag, high-rupture rated)
T4AH (5mm x 20mm, 250V, 4A,
time-lag, high-rupture rated)
Operations Guide – DOC. 6456B