Crestron Adagio AES Operation Manual page 23

Crestron Adagio™ AES
Hardware Connections for Out-of-the-Box Functionality (Shown with Tuner Cards in Slots 1 & 2)
APAD
INPUT(S)
FROM AAS (OPTIONAL):
AAS-1: SOURCE 7
AAS-2: SOURCES 7 & 8
AAS-4: SOURCES 7-10
INPUT FROM
CEN-IPOD
(OPTIONAL)
OUTPUT TO
CORRESPONDING
SOURCE INPUTS
ON AAE
(IF INSTALLED)
EACH PAIR OF SPEAKER OUTPUTS CORRESPONDS TO A ROOM NUMBER.
Custom Program
Connections
Operations Guide – DOC. 6456B
NOTE: The AESI (International version) requires a power cord that is harmonized
to the country's national and local electrical code. Each inner wire in the cord should
be at least 16 AWG or (1.5 mm
of the cord should be at least 60ºC. The cord length should be 1.5 meters to 2 meters.
C2N-DBF12 C2N-DBF12
TO ROOM SPEAKERS:
Refer to the following when not using the out-of-the-box functionality:
WARNING: To prevent injury and / or equipment damage due to electric shock,
disconnect power from the AES prior to making any wiring connections.
Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to "Network Wiring" on page 17 before attaching the 4-position
terminal block connectors. Apply power after all connections have been made.
CAUTION: Speakers must be rated to full available output.
CAUTION: Do not bridge speaker outputs.
CAUTION: All tuner cards should be securely installed in the AES.
CAUTION: Devices such as the AAS and the AAE must be fully grounded to the
AES. Additionally, any other source devices should be grounded to the AES as well.
Entertainment System
2
) and rated for at least 500V.The temperature rating
C2N-DBF12 C2N-DBF12
FROM LINE
Entertainment System: Adagio AES • 19
APAD
NET:
TO AAE
(OPTIONAL)
LAN:
CONNECT TO DHCP ROUTER;
REQUIRED FOR USE WITH
CEN-IPOD and AAS
GROUND:
TIE ALL SOURCE AND AAE
GROUNDS TO AES
GROUND TERMINAL
POWER:
VOLTAGE