Hardware Hookup - Crestron CP3 Operation Manual

3-Series Control Systems
Stacking
Connect the Device
14 • 3-Series Control Systems: CP3 & CP3N
Ear Attachment for Rack Mounting
4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the
opposite side.
Four "feet" are provided with the CP3 so that if the unit is not rack mounted, the
rubber feet can provide stability when the unit is placed on a flat surface or stacked.
These feet should be attached prior to the hookup procedure. Refer to the following
illustration for placement of the feet.
Foot Placement for the CP3
Mounting Feet (2002389), QTY. 4
NOTE: No more than two CP3 units should be stacked.

Hardware Hookup

Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to "Network Wiring" on page 12 before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the CP3, note the following:
• Use Crestron power supplies for Crestron equipment.
• The included cable(s) cannot be extended.
Crestron CP3 & CP3N
Use Cover Screws
Operations Guide – DOC. 7316C